THE TOOLS YOUR GRANDPA WOULD HAVE USED.
Grandpa says, “Use the right tools for the job.” Well, grandpa, these are the right tools. The reimagined hammer has an ergonomic grip and balanced weight to give both precise control and driving power. The hammer head faces can be switched between steel, brass, rubber, and nylon. There are twelve solidly built, precision punches for pins on all your guns. Each pin is clearly labeled and ringed with rubber for added grip. Plus, the Pin Alignment Tool holds even the smallest pins precisely over their holes to easily drive them in.
- 10 Steel Pin Punches with Rubber Rings for Grip
- Pin Alignment Tool
- Balanced, Ergonomic Hammer with Interchangeable Hammer Heads
- 4 Interchangeable Hammer Heads
ADJUST TO THE SITUATION WITH INTERCHANGABLE HAMMER HEADS.
The driving faces can easily be switched between steel, brass, rubber, and nylon – whichever is best for the job at hand.
- Rubber Hammer Head
- Brass Hammer Head
- Steel Hammer Head
- Nylon Hammer Head
- Kickstand Tool Case with Peg Board Holes
START PINS OUT WITHOUT GETTING YOUR FINGERS IN THE WAY
Rather than a finger-smashing, pin launching cuss-fest, use the Pin Alignment Tool to hold the smallest pins precisely over their holes to easily drive them in.
PIN PUNCHES FOR ANY GUN FROM YOUR MSR TO GRANDDAD’S HEIRLOOM SIDE-BY-SIDE.
The 10 hardened steel punches and the nylon punch are clearly labeled and ringed with rubber for added grip to dampen vibration.
- 5/16″ Nylon Pin Punch
- 9/32″ Steel Pin Punch
- 1/4″ Steel Pin Punch
- 7/32″ Steel Pin Punch
- 3/16″ Steel Pin Punch
- 5/32″ Steel Pin Punch
- 9/64″ Steel Pin Punch
- 1/8″ Steel Pin Punch
- 3/32″ Steel Pin Punch
- 5/64″ Steel Pin Punch
- 1/16″ Steel Pin Punch